Glove Compartment Lid

Glove Compartment Lid

Special tools, testers and auxiliary items required

• 4 mm cotter pin driver

Removing






- Remove the glove compartment. Refer to => [ Glove Compartment ] Glove Compartment.

- Remove hinge pins - 1 - from lid dampening mechanism - 2 -.

• Ignore - arrow -.

- Remove the glove compartment unlock motor (V327). Refer to => [ Glove Compartment Unlock Motor V327 ] Glove Compartment Unlock Motor V327.

- Lay the glove compartment with the top side on a soft surface.






- Remove the left and right hinge pins - 3 - using a 4 mm cotter pin driver - 1 - - arrow -.

- Note compensation disc on right side - 2 -.

- Open the glove compartment cover by pulling the control cable.

- Remove the glove compartment cover and lead the control cable out of the glove compartment.

Installation

Install in reverse order of removal. Note the following:

- Pay attention to compensating disk - 2 - when inserting the right hinge pin.

- Adjust the glove compartment cover control cable. Refer to => [ Glove Compartment Cover Control Cable, Adjusting ] Glove Compartment Cover Control Cable, Adjusting.