Brake Light Switch: Service and Repair

Brake Light Switch

• The vehicle may have a brake lamp sensor depending on the model.

• Look at the color piece on the brake lamp sensor.

• Brake lamp sensor, removing and installing, refer to => [ Brake Lamp Sensor ] Brake Lamp Sensor.

- Remove the driver side trim panel..

Removing

- Separate the electrical connection.

- Remove brake light switch by turning 45° to left.

Installing

- Installation is performed in reverse sequence.

- Before installing, pull out plunger completely.

• When installing switch, brake pedal must not be operated.

• When inserting brake light switch, plunger adjusts itself automatically.

• After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).

- Install the trim on the driver side..