Impact Member, Vehicles Through MY 2012

Impact Member, Vehicles through MY 2012

Removing






• When installing, position cable ties in same place.

- Remove the front bumper cover.

- Disconnect the electrical connector - 4 - on the horns and free up the electrical wiring harness - 3 - on the horn bracket.

- Free up the washer nozzle water drain hose by disconnecting the cable tie - 1 -.

- Remove the bolts - arrows - and the bumper cover spacer - 2 -.

- Remove the impact bar - 5 - from the mounts.

• Pry the impact bar out of the mounts if it is not easy to remove.

Installing

• Tightening specifications, refer to => [ Impact Member Assembly Overview for Vehicles through MY 2012 ] Impact Member Assembly Overview For Vehicles Through MY 2012.

Install in reverse order of removal. Note the following:

- Install the front bumper cover.