Sunroof Assembly Overview

Sunroof Assembly Overview






1 Frame

• Removal:

• Fold the seat backrest all the way back.

• Lower the headliner.

• Sunroof panel removed

• Remove the water drain hoses.

- Remove the nuts - 4 - and screws - 2 - on the frame.

- Lift the frame through the rear door and out of the vehicle.

• Installing:

- Attach the frame with the nuts and screws loosely to the roof.

- Connect the water drain hoses.

- Secure the frame in the bodying using a 12 mm drill bit on the front right side and a 10 mm drill bit and then tighten the nuts to the tightening specification beginning at the front center and working back on the left and right sides.

- Tighten the screws in the same sequence to the tightening specification.

2 Bolt

• 8 Nm

3 Wind deflector

• Removal, refer to => [ Wind Deflector ] Wind Deflector

4 Nut

• 8 Nm

5 Bolt

• 4 Nm

6 Motor

• Removing

• Remove the motor only when the cover is closed.

- Interior lamps removed.

- Disconnect the motor connectors.

- Remove the screws - 5 - and remove the motor through the headliner cut-out.

• Perform and adaptation after removing and installing a motor. Refer to => [ Motor Adaptation ] Motor Adaptation.

Attaching points for the frame






- When installing the sunroof, the frame must be attached at the front right side - arrow - from the first nut - 1 - with a 12 mm drill and....

- ...the rear left side (oblong hole) - arrow - in front of the last screw - 1 - with a 10 mm diameter drill.






- Starting from the center, tighten the nuts and screws from the front and working toward the rear to the tightening specification=> [ Sunroof, Sedan ] Sunroof, Sedan.