Headrest Guide

Headrest Guide

Removing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling airbag units (for example, when disconnecting the harness connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Remove the front seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Attach the front seat to the (VAS 6136). Refer to => [ Front Seats, Installing on the ] Front Seats, Installing on the Fixture For Seat Repair (VAS 6136).

- Remove backrest panel:

• Two section backrest cover. Refer to => [ Backrest Cover (Section Two) ] Backrest Cover (Section Two).

• One section backrest cover. Refer to => [ Backrest Cover (Section One) ] Backrest Cover (Section One).

- Remove the cover and upholstery/headrest from the backrest => [ Backrest Cover and Padding, Super Sport Seat ] Backrest Cover and Padding, Super Sport Seat.

Headrest guide without release button

- Press the retaining tabs - arrows - on the headrest guide toward the center of the headrest guide.

- Hold the retaining tabs - arrows - down.

- Pull headrest guide - 1 - upward out of backrest frame - 2 -.

Installing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

•

Installation is performed in the reverse of removal, but note the following:

Headrest guide without release button

• When sliding the headrest guide - 1 - in, make sure the tab - 3 - engages correctly on the backrest frame - 2 -.

• Ensure retaining tabs - arrows - are engaged in the backrest frame correctly.

Continuation for headrest guide without and with release button

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.