Exterior Mirror Turn Signal Lamps, Through 05.09

Exterior Mirror Turn Signal Lamps, through 05.09

Removing






- Remove the mirror glass.

• To protect the paint in the area around the mirror housing, tape it off with a soft cloth.

- Remove the screws - 4 and 5 -.

- Release the retaining tabs - 3 - in the - direction of arrow A -.

- Release the retaining clip - 1 - and remove the exterior rearview mirror housing - 2 - from the cover - B arrows -.

- Press the mirror adjusting unit down and pull the exterior rearview mirror housing - 1 - upward slightly.






- If applicable, disconnect the lane change assistance warning lamp electrical connector - 2 - on the front side of the mirror adjusting unit mount - 3 -.

- Pull the exterior mirror housing upward and disconnect the electrical connector - 3 -.






- Remove the screws - 1 and 4 -.

- Tilt the turn signal housing - 2 - out of the exterior rearview mirror housing - arrow -.

Installing






• Tightening specifications, refer to => [ Exterior Rearview Mirror Turn Signals through 05.09, Overview ] Exterior Rearview Mirror Turn Signals Through 05.09, Overview.

Install in reverse order of removal, observing the following:

• The entire exterior mirror turn signal must be replaced if a Light Emitting Diode (LED) is faulty.

- Insert the tip of the turn signal in the slit in the exterior rearview mirror housing - 3 - - arrow A -.

- Tilt the turn signal bulb housing - 4 - into the exterior rearview mirror housing - arrow B -. The locking tab - 2 - must engage in the mount - 1 -.

- Install the exterior rearview mirror housing.