Dynamic Steering Overview

Dynamic Steering Overview






1 Power Steering Pump

• With an electric control valve

• The control valve is only installed on vehicles with 6- and 8-cylinder engines.

• The power steering pump and control valve are one component and are replaced together.

• Installation location in vehicles with 4 and 6-cylinder engines: on the left front of the engine (belt drive).

• Installation location on vehicles with 8-cylinder engines: on the rear left of the engine (chain drive).

2 Actuator

• Must not be loosened or removed from the steering column.

• The actuator and steering column are one component and are replaced together.

• The system must be calibrated if the actuator is replaced. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.

• Removing and installing, refer to => [ Steering Column ] Steering Column

3 Active Steering Control Module (J792)

• The basic setting must be made if the active steering control module is replaced. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.

• Removing and installing, refer to => [ Active Steering Control Module (J792) ] Active Steering Control Module (J792)