Convertible Top Cover Hydraulic Cylinder

Convertible Top Cover Hydraulic Cylinder

Injury risk.

• There must be no pressure inside the hydraulic system when performing the following work.

Removing






- Follow cleanliness rules. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Open the convertible top until the displayed position of the top and the convertible top compartment cover is reached.

- Turn off the ignition and press the convertible top operation switch (E137) - 1 - for approximately 5 seconds.






• The pressure in the hydraulic system will come down.

- Left: remove the hydraulic pump, refer to => [ Hydraulic Pump ] Hydraulic Pump.






- Remove the luggage compartment side trim..

- Release the clip - 3 - on the hydraulic cylinder - 4 - with a screwdriver and remove the bolt to the side.

- Remove the clips - 1 - and then remove the bolts - 5 -.

- Remove the hydraulic cylinder from out of the hinge - 2 -.

- If the hydraulic cylinder is being replaced:

• Removing the hydraulic line, refer to => [ Hydraulic Line On Cylinder ] Hydraulic Line On Cylinder.

- If one hydraulic line is being replaced:

• Remove the hydraulic line from the hydraulic cylinder. Refer to => [ Hydraulic Line On Cylinder ] Hydraulic Line On Cylinder.

• Remove the hydraulic line from the valve block. Refer to => [ Hydraulic Line On Valve Block ] Hydraulic Line On Valve Block.

Installation

Install in reverse order of removal. Note the following:

- Install the hydraulic line. Refer to => [ Hydraulic Line On Cylinder ] Hydraulic Line On Cylinder and => [ Hydraulic Line On Valve Block ] Hydraulic Line On Valve Block.

- Hydraulic system, filling and bleeding, refer to => [ Hydraulic System, Filling and Bleeding ] Hydraulic System, Filling and Bleeding.