Lumbar Support Adjustment Switch

Lumbar Support Adjustment Switch

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove tunnel side trim panel. Refer to => [ Sill Side Trim ] Sill Side Trim.

- Disconnect the connector - 4 -.






- Remove the bolts - 2 -.

- Remove the lumbar adjustment switch - 1 - from the trim - 3 -.

Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

- Route the wires as close to the connector - 4 - as possible.






• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery Ground (GND) cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the Diagnostic Trouble Code (DTC) memory must be checked, deleted and checked again. Refer to Vehicle diagnostic tester.

For the correct tightening specifications. Refer to => [ Electrical Components Assembly Overview ] Electrical Components Assembly Overview.