Cylinder Block Assembly: Testing and Inspection

Piston and Cylinder Bore, Checking

Special tools, testers and auxiliary items required

• Cylinder Gauge (VAS 6078) or Inside Micrometer Set 18-100 mm (US1033/S)

Pistons, Checking





- Measure approximately 15 mm from the lower edge at a 90° angle to the piston pin axis using a 75 to 100 mm external micrometer.

• Maximum deviation from nominal dimension: 0.03 mm.






Measuring Cylinder Bore





- Measure in a diagonal sequence at 3 positions transversely - A - and longitudinally - B - using a (VAS 6078) or (US1033/S).

• Maximum deviation from nominal dimension: 0.08 mm.






Piston Ring End Gap, Measuring





- Push the piston ring squarely from above down to approximately 15 mm from the bottom end of the cylinder.

- Use a piston without a piston ring for sliding in.






Measuring Piston Ring Side Clearance





- Clean the piston ring groove before checking.