Rear Brakes With Electronic Parking Brake Overview

Rear Brakes with Electronic Parking Brake Overview

• Only install complete repair kit.

• Rear wheel brake with automatic adjustment.






1 - Self-Locking Bolt

• 12 Nm

2 - Electromechanical Parking Brake Actuator

• Electromechanical parking brake control module, removing and installing, refer to => [ Electromechanical Parking Brake Control Module (J540) ] Service and Repair.

• Actuator, removing and installing, refer to => [ Electromechanical Parking Brake Actuator ] Service and Repair.

3 - Seal

• Always replace.

4 - Self-Locking Bolt

• 35 Nm

• Always replace.

• When loosening and tightening, counter-hold at guide pin.

5 - Spacer

6 - Brake Hose

• To the brake caliper, 20 Nm.

• Do not disconnect brake line when changing brake pads.

• Make sure that retaining tabs are seated correctly in bracket.

• Install hose without twisting.

7 - Brake Caliper Housing

• Do not remove the brake hose when changing the brake pads.

• Brake caliper, servicing.

• It is possible to install brake carrier with brake caliper.

• Removing and Installing, refer to => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier.

• Replacing, refer to => [ Rear Brake Caliper, Replacing ] Rear Brake Caliper, Replacing.

8 - Brake Carrier with Guide Pins and Cap

• Supplied as an assembled replacement part with sufficient grease on guide pins.

• If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.

• It is possible to install brake carrier with brake caliper.

• Removing and Installing, refer to => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier.

9 - Brake Pads

• Wear limit, refer to => [ Brakes PR Codes ] Application and ID.

• Must always be replaced together on both sides of axle.

• Removing and Installing, refer to => [ Rear Brake Pads ] Rear Brake Pads.

• Check brake pad thickness.

• It is possible to install brake carrier with brake caliper.

• The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.

10 - Brake Pad Retaining Plate

• Always replace when pads are replaced.

• The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.

11 - Wheel Bolts

12 - Bolt

• 5 Nm

13 - Brake Rotor

• Wear limit, refer to => [ Brakes PR Codes ] Application and ID.

• Removing and Installing, refer to => [ Rear Brake Rotor ] Rear Brake Rotor.

• Must always be replaced together on both sides of axle.

• Brake rotor allocation, refer to => [ Brakes PR Codes ] Application and ID.

14 - Hex Head Bolts

• 10 Nm

15 - Brake Shield

• Removing and Installing, refer to => [ Rear Brake Shield ] Rear Brake Shield.

16 - Bolt

• 100 Nm + 90° turn

• Replace

17 - Bolts

• 100 Nm + 90° turn

• Replace