Wheel Bearing Unit

Wheel Bearing Unit

Removing

- Remove wheel bearing housing. Refer to => [ Wheel Bearing Housing ] Wheel Bearing Housing.

- Clamp the wheel bearing housing in a vise with protective covers.

- Remove the bolts - 1 - and the wheel bearing unit - 2 -.






• Avoid contaminating with dirt and damaging the seal when setting down/storing.

• The wheel bearing - 1 - must face up in order to remove the wheel bearing unit.






• Always set the wheel bearing unit down on the wheel hub - 2 -.

• Never reach into the inside when lifting the wheel bearing.






• Hold the wheel bearing only on the outside.

The same procedure also applies to the wheel bearing without a wheel hub.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications, refer to => [ Wheel Bearing Housing, Wheel Bearing Unit and Coil Spring Shock Absorber Overview, AWD ] Wheel Bearing Housing, Wheel Bearing Unit and Coil Spring Shock Absorber Overview, AWD.