Alignment: Specifications

Wheel Alignment Specified Values

Front and all wheel drive

Specifications valid for all engine versions

If the vehicle has RHD and the standard chassis (1BA), then check and adjust the camber on the front axle according to the height of the vehicle.






* Wheel stop on outer wheel is reduced by this amount. It can also be indicated negatively in alignment computer, depending on manufacturer.

* If the vehicle has RHD and the standard chassis (1BA), then check and adjust the camber on the front axle according to the height of the vehicle.






* Wheel stop on outer wheel is reduced by this amount. It can also be indicated negatively in alignment computer, depending on manufacturer.











Camber adjustment values on the front axle for RHD vehicles and standard chassis (1BA)

If the vehicle has RHD and the standard chassis (1BA), then check and adjust the camber on the front axle according to the height of the vehicle.






- Measure the vehicle height - a - at the right and left front wheels between the center of the wheel and the lower edge of the fender.

• Maximum permissible difference in height between the right and left 10 mm


The camber values are defined in the following table based on the vehicle heights at the front axle.