Sunroof / Moonroof: Adjustments
ADJUSTING STEEL SUN ROOFDescription:
The steel sun roof has two functions:
a) Sliding roof b) Lifting roof
Roof lid must be closed to switch to lifting operation. Operation is mechanical after over coming a pressure point. A switch was employed on earlier models,
Open steel sun roof by about 5 cm (2").
Press off headliner frame at front and push back a little.
Close sun roof lid and push back headliner frame all the way.
Installation:
Close steel sun roof. Pull headliner frame forward uniformly. Open steel sun roof slightly, holding headliner frame by hand. Press in holding clips for headliner frame.
Front Height Adjustment:
Ideal adjustment of steel sun roof would be lid 1 mm (0.040") deeper than roof panel surface.
Loosen screws (1) and make adjustment with height control screw (2).
Tighten screws (1), pressing in at same time.
Rear Height Adjustment:
Ideal adjustment of steel sun roof would be lid 1 mm (0.040") higher than roof panel surface
Loosen screws on gate holder
Lid can now be adjusted in slots
Tighten screws
Lifting Position:
For lifting position steel sun roof lid must rest against front roof opening.
Correct adjustment by moving guide pins.