Distributor: Service and Repair

REMOVING AND INSTALLING DISTRIBUTOR





- Turn crankshaft to TDC mark (ignition in cylinder no. 1) with a 30 mm wrench socket.





- Take off cap (1).





- Pull off plug (1).
- Lift off clamps (2 and 3).
- Remove distributor cap.





- Remove distributor rotor (1) and dust cap (2).
- Pull off vacuum hose (3).





- Check position of distributor rotor - it should point to notch on distributor.
- Correct by turning crankshaft, if necessary.





- Loosen nut
- Pull out distributor.

Installation Note:





- Check seal (1). replacing if necessary.

Installation Note:





- Turn distributor rotor clockwise toward mark On housing approx. 30°(A).
- Insert distributor.
- Adjust ignition timing after finishing installation.