Installing Exchange Transmission

Transmission Identification:





BMW code marked on intermediate case section.
Transmission Type: Getrag 265/6.

Procedure:
- Remove transmission.





- Transfer spring (1) and release lever (2) with release (3).




Installation Notes:
Pack lubricating groove (N) with Molykote Longterm 2.
Give guides (F) and bearings (L) a light coat of Molykote Longterm 2.
Non-conformance could cause bearing to seize on the guide sleeve.





- Push back locking sleeve (1).
- Drive Out cylindrical pin (2).
- Transfer shift rod joint.
- Transfer rubber mounts with cross member, exhaust carrier and backup light switch.

NOTE: Check the oil level after installation of the transmission.