Powertrain Management: Technical Service Bulletins

• Customer Interest
  • Fuel System - Fuel Cap Tether Is Broken Or Lost
  • Engine - Hydraulic Lock
  • Fuel - Engine Will Not Start
  • On-Board Computer - Stop Watch Function Inoperative
  • Fuel - Injector Cleaning Procedure
  • Fuel System - Damage Caused By Fuel Contaminants
• By Symptom
  • Abnormal wear/deterioration
    • Engine - Hydraulic Lock
    • Fuel System - Damage Caused By Fuel Contaminants
  • Customer Interest
    • Fuel System - Fuel Cap Tether Is Broken Or Lost
    • Engine - Hydraulic Lock
    • Fuel - Engine Will Not Start
    • On-Board Computer - Stop Watch Function Inoperative
    • Fuel - Injector Cleaning Procedure
    • Fuel System - Damage Caused By Fuel Contaminants
  • Driveability
    • Fuel - Engine Will Not Start
    • Engine - Fuel Quality and Carbon Accumulations
    • Fuel - Injector Cleaning Procedure
  • Erratic Operation
    • Fuel - Injector Cleaning Procedure
  • Inoperative
    • On-Board Computer - Stop Watch Function Inoperative
  • Leaks
    • Engine - Hydraulic Lock
  • Noise
    • Fuel - Engine Will Not Start
  • Odors
    • Emissions - Rotten Egg Smell From Exhaust
  • Poor performance
    • Engine - Fuel Quality and Carbon Accumulations
• All Technical Service Bulletins
  • Emissions - Pressure Cont. Crankcase Ventilation Info.
  • Computers, Controls - Programming VS Veh. Data Status
  • Compuetrs/Controls - Recommended Diagnostic Procedures
  • Computers - ISTA Diagnosis On Vehicles Prior To E46
  • Fuel System - High Alcohol Fuel Detection
  • Fuel System - Fuel Cap Tether Is Broken Or Lost
  • MoDic(R) - Current Diagnostic and Coding Software
  • MoDic(R) - Updated Software
    • Overview
    • Downloading
    • Steps (For Modic II)
    • Downloading Steps (For Modic I)
    • Encodable Control Modules
  • MoDic(R) System - Undefined Software Message
  • Updated MoDic(R) Software - C11.0 ZCS Coding
    • Overview
    • How to Load C11.0 Software With the MODIC Station
    • Label Printing
    • Parts Information
  • DIS Schematic Information
    • Overview
    • Document Abbreviations
    • Colored Frames and Colored Window Headers
    • Printed Documents
    • Moving About the Schematic
  • Vehicle - Basic Troubleshooting
  • Electrical/Electronic Systems - Troubleshooting Hints
    • Overview
    • Verify the Complaint and Verify the Complaint Is A Malfunction
    • Systematic Troubleshooting
    • Inputs, Processing, and Outputs
    • Common Sense Hints
  • Engine - Hydraulic Lock
  • Fuel Pump Relay Bridging Switch/Cable Assembly
  • Fuel - Engine Will Not Start
  • Engine - Fuel Quality and Carbon Accumulations
  • On-Board Computer - Stop Watch Function Inoperative
  • Ignition - Spark Plug Application
  • Ignition - Spark Plug Application Charts
  • Ignition - Spark Plug Application Chart
  • Spark Plug/Engine Oil Capacity Reference Chart
  • Intake and Vacuum System - Leak Detector
  • Fuel Injector - Cleaner Literature
  • Fuel - Injector Cleaning Procedure
  • Fuel - Lubricants For Installaling Injectors
  • Special Tools - Simulator Tool For Bosch Oxygen Sensors
    • Overview
    • Individual Parts of the Simulator
    • Operator Control/ Panel of Simulator
    • Connecting the Simulator
    • Test 1: Oxygen Sensor Testing
    • Test 2: Oxygen Sensor Voltage
    • Test 3: Simulation of Probe Voltage
  • ABS/ASC - Warning Lights On During Dynamometer Test
    • Overview
    • State Motor Vehicle Agency Letter
    • Owner Letter
  • Starting - Ignition Key Cutting Services Caution
  • Fuel - Engine Compartment Return Fuel Hoses
  • A/T - Adjusting Selector Lever and Accelerator Cable
  • Emissions - Rotten Egg Smell From Exhaust
  • Electrical/Electronics - New Test Cables
  • Model Year VIN Identification
  • New Special Tool - MoDic(R) Replacement Cable
  • Updated MoDic(R) Software - P8.0 Programming
    • Overview
    • Engine Control Module Flash Programming Features
    • Programming the Control Module
      • Overview
      • 2. "Exchange Control Module"
      • 3. "Exchange EPROM"
      • 4. "Adjustment EWS - DME Vehicles From 1/95"
      • 5. "Clear Adaptation Values"
    • How to Load V8.0 Software With the Modic Station
    • Label Printing
    • Prerequisites For Programming
  • Diagnostic Module For Service Tester - Leasing Program
  • Tools - Service-Tester Universal Adapter
  • MoDic(R) - Loss of Program
  • Updated MoDic(R) Software - P11.0 Programming
    • Overview
    • Program Highlights
    • Flash Programming Features
    • Programming the Control Module
      • Overview
      • 1. Determine Customer Service Measures
      • 2. Exchange Control Module
      • 3. Exchange EPROM
      • 4. Adjustment EWS - DME Vehicles From 1/95
      • 5. Clear Adaptation Values
    • Diskette Contents
    • How to Load V11.0 Software With MODIC Station
    • Label Printing
    • Prerequisites For Programming
    • Parts Information
  • Updated MoDic(R) Diagnostic Software - D12.0
  • Fuel Quality Letter
  • Fuel System - Damage Caused By Fuel Contaminants
  • Computers/Control - Loading/Activation Of Enabling Codes