Front
- Remove front wheels.- Pry off plastic caps (1).
- Pull off plug for brake pad wear indicator on left side.
- Unscrew guide bolts (2).
Installation note:
- Only clean guide bolts - don't lubricate.
- Check guide bolts for condition, renew if necessary.
- Tightening torque: 30-35 Nm (22-25 ft lbs).
- Press out clamp (3).
- Pull off brake caliper toward front.
- Remove outer brake pad.
- Inner brake pad is located in piston with spring (4).
Installation note:
- Check pad thickness.
- Renew brake pads always on both calipers of one axle. Note make of pads.
- Press piston back completely.
- Clean brake pad guides and recesses with a special brush.
- Check dust cover for damage.
- Reverse procedure to install.
NOTE: For additional information see Removal and Installation Notes. Fundamentals and Basics