Repair Procedure

Disconnect rear sway bar and allow it to hang to allow access to half-shaft. If left side is being worked on, remove rear section of exhaust system for access.





Remove hub nut (1).





Remove bolts, separate half-shaft from output flange. and hang from car with a piece of wire.





Mount special tools as shown, press out halfshaft, and remove.

Note:
6 332 113 can be used in place of 6 332 117





Remove caliper mounting bolts (1) and hang caliper out of the way on a piece of wire.





Remove brake disc.





Drive out hub with special tool 33 4 010.





Remove snap ring.





Pull out wheel bearing with special tools as shown.

Note:
Tool 33 3 260/262 can be used as an alternate.





Install new wheel bearing with special tools as shown.

Note:
Tool 333 260/264 can be used as an alternate.





Reinstall snap ring.





Pull in new hub as shown.





Reinstall brake. Tighten retaining bolt to 16 Nm.





Reinstall caliper. Tighten caliper mounting bolts to 65 Nm.





Mount special tools as show, and pull in new half-shaft.





Fasten half-shaft to output flange using new bolts and plates (1). Tighten to 100 Nm.





Tighten hut nut to 300 Nm and loosen two turns.





Mount the special tools as shown. Repeat procedure described in Attachment 1.





If new assembly is found to be in order, tighten hub nut to 300 Nm and stake in place.