Removing and Installing Clutch Housing

- Remove transmission.

Cars with DME:
- Remove heat shield.





CAUTION:
Check installed position of DME sensors. Plugs must not be mixed up.

- Unscrew bolts (arrows).
- Pull Out speed sensor (3) and reference mark sensor (4).

Installation Note:
Check O-rings.
Coat sides sensors with Molykote Longterm 2.
Install speed sensor (3) in bore (D) and reference mark sensor (4) with ring (5) in bore (B).
Engine cannot be started, if plugs are mixed up.





Installation Note:
Check O-rings.
Face surface of DME senders must be free of grease and dirt.





- Remove position sender (1).
- Unscrew clutch housing.
- Use a Torx wrench to unscrew Torx bolts.

IMPORTANT! - INSTALLATION:
Torx bolts must be installed with washers to avoid an increase in breaking-loose torque.
Tightening torque.