Rear

- Remove rear wheels.



- Press off plastic caps (1).
- Pull off plug for brake pad wear indicator on right side.



- Unscrew guide bolts (2).

Installation note:
- Only clean guide bolts - don't lubricate.
- Check condition of guide bolts, replace if necessary.
- Tightening torque: 30-35 Nm (22-25 ft lb).




- Press out clamp (3).
- Pull off floating caliper from behind.



- Remove outer brake pad.
- Inner brake pad seats in piston with spring.

Important:
- Brake pads must always be replaced on both brake calipers of one axle.
- Check make.

Installation note:
- Push back piston completely.

- Clean brake pad guides and recesses with a brush.
- Check dust cover for damage.
- Reverse procedure to install.

NOTE: For additional information see Removal and Installation Notes. Fundamentals and Basics