Removing and Disassembling Additional A/C Unit

- Lift out cooling box and trim (left and right sides).





- Unscrew screws on left and right sides.





- Take off trim panel (upper section) and disconnect plug.

- Remove rear seats. Service and Repair





- Unscrew screws on left and right sides.

- Take off side trim panels.





- Unscrew screws and take off air duct.

Removing TRANSISTOR (for Blower Switch):





- Pull off plug.

- Unscrew screws.

Removing end Disassembling CONTROL UNIT





- Unscrew screws.

- 1 = Lamp





- Lift out control cam (blower switch) and unscrew screw.





- Unscrew screws and lift out printed wiring board.

Removing FAN MOTOR





- Pull off plug.

- Unscrew screws on left and right sides.

- Lift out clamps.

- Lift out housing upper section together with fan motor.

Installation:
Make sure that housing sections are placed together correctly.

Removing EVAPORATOR





- Discharge pressure in air conditioner with help of a valve core remover on the intake pressure regulator.

Note: Discharge, charge and check air conditioner for leaks after finishing installation.





- Unscrew screw on expansion valve and take off lines.

Installation:
Replace gaskets.





- Disconnect plug.

- Unscrew screws on left and right sides.





Installation:
Position gasket prior to installation.

Removing EXPANSION VALVE





- Unscrew screws.

Installation:
Replace gaskets.

Removing TEMPERATURE SENSOR





- The temperature sensor can be pulled out of the evaporator after removing the air duct.

- Reverse procedure to reassemble and install.