Removing and Installing Guide Sleeve For Clutch Release

Removing and Installing Guide Sleeve For Clutch Release

- Remove transmission.





- Lift out spring (1) and remove release lever (2) with thrust bearing (3).

Installation Notes:




Pack lubricating groove (N) with Molykote Longterm 2.
Coat guides (F) and bearings (L) with Molykote Longterm 2 lightly.
Non-conformance could cause release bearing to seize on guide sleeve.





- Unbolt and remove guide sleeve.

NOTE: Spacer thickness (arrow).

Installation Notes:
Replace gasket.
Sealing surface must be thoroughly clean and dried of oil.

- Adjust bearing free play to 0.0 - 0.09 mm (0.00 - 0.0035 in) by installing proper thickness of spacer.





- Measure distance (A) from sealing surface to bearing outer race.





- Measure distance (B) from inside surface to sealing surface through opening in guide sleeve, with gasket installed.

EXAMPLE:

A 5.2 mm (0.205 in)
- B 3.2 mm (0.126 in)
_________________
2.0 mm (0.079 in) spacer thickness