Removing Holding Cover For Distributor

Distributor:

REMOVING HOLDING COVER FOR DISTRIBUTOR
- Unscrew distributor rotor.

Installation Note: Tightening torque = 6 Nm (4 ft. lbs.).

Distributor:

- Unscrew adapter.

Distributor:

Installation Note:
- Install adapter so that the bore in the adapter takes the dowel pin in the camshaft.
- Tightening torque 24 Nm (17 ft. lbs.).

Distributor:

- Unscrew screws and take off holding cover.

Distributor:

INSTALLATION:
- Replace seals on back of cover and underneath screws.
- Apply Special Tool 11 3 220 on the camshaft.
- Lubricate sealing lip of radial oil seal with oil and mount the cover (do not yet tighten).

Distributor:

- Center cover with Special Tool 11 3 210 and tighten.

Distributor:

REPLACING RADIAL OIL SEAL IN HOLDING COVER
- Lift out old seal and drive in new seal against the stop with Special Tool 11 3 200.
- Lubricate sealing lip of seal with oil prior to mounting the cover.