R & R Control Module (Diagnosis Unit)

WARNING: Review Service Precautions. Improper handling could cause activation of the airbag(s) and lead to injuries!

REMOVE
- Disconnect battery and cover negative pole or terminal.
- A waiting period of approximately 5 minutes should be observed before beginning electrical work to allow the capacitor charge to dissipate.
- Remove lower steering column trim section.





- Disconnect plug connection for airbag (orange).

Control Module R&R:

- Remove glovebox and fresh air nozzle.
- Remove screws.
- Disconnect connectors (orange) and remove control module.

Control Module R&R:

1 - Control units (Tempomat, anti-theft alarm (DWA), etc.)

2 - Supplemental Restraint System (SRS) control module

3 - Plug connection on front sensors

4 - Plug connection for wiring harness

5 - Plug connection for driver airbag

INSTALL
- Install in reverse order.

NOTE: Arrow on module faces forward.





NOTE: Make sure lock is seated correctly.

- Check for possible trouble codes.
- Verify proper system operation.