Seat Cushion

Rear seat cushion, removing and installing (power seats)

- Pull front of cushion up and out of clip.

- Remove seat control knobs and remove trim screws behind them.




- Pull up seat belt lock trim and remove from seat belt lock.




- Rear door edge trim retaining clip (arrow).
- Pull off door seal at bottom rear corner of door. Tilt door edge trim outward and remove.




- Unbolt rear seat belt lock mounting bolt (A) and disconnect wiring harness connector (B).

- Lift front of seat cushion, sliding seat tracks off body anchors and unhooking locating rods from backrest.

- Detach electrical harness connector and lift cushion out of car.

- Installation is reverse of removal.
- Guide seat cushion locating rods into backrest holes.
- Guide seat tracks into body anchors on floor.