With SRS

Caution! Conform with safety regulations. Improper handling could cause unwanted activation of SRS and in turn lead to injury!

- Disconnect battery and cover negative pole or terminal.





- Lift cap out of lower steering column casing section and disconnect plug.





- Unscrew four screws with Special Tool 00 2 110.

Installation:
Tightening torque 8 Nm





- Pull off plug and remove SRS unit.

Caution! Only lay the SRS unit aside (in trunk) with the impact pad facing up.

Installation:
Be careful not to pinch the wires.

- Move steering wheel to straight ahead position (marks on steering gear and steering spindle aligned).





- Unscrew nut and remove with washer.

Important! The steering wheel can only be pulled off after unlocking the steering lock.





Installation:
Lockpin (1) must engage in opening (2).
Replace self-locking nut.
Tightening torque 80 Nm.





Note: Loosening the nut activates spring lock (1), which holds the contact ring in center position.

Adjusting Center Position When Necessary:





- Press down spring (1).

- Turn contact ring clockwise or anticlockwise against stop.

- Turn back about 3 turns until the arrows for center position are aligned.

- Release spring (1).