Defect Code 02

Defect Code 02:

Explanation:

Defect on the connection links (interface) to EML (DKV, DKE, DKR signal).

Possible cause:

Short or break on one of the wires to the EML

Defect during synchronization with the EML control unit

Troubleshooting:

Switch off ignition and detach control unit connector.

Check DKV, DKR, DKE line from ABS/ASC+T Pin 14, 6, 8 to the EML Connect control unit and switch on ignition.

Measure frequency of the DKV, DKR, DKE signal with <-M-> , nominal value approx. 100 Hz.

Repair defective wire if necessary.

If no defect can be found, clear defect code memory.

Note:

The same DKV signal is supplied to the EGS control unit. Read out EGS defect code memory and, if necessary, also check wire to the EGS.