Defect Code 1

Defect Code 1:

Malfunction: Tilt sensor (installed?):

Troubleshooting: If tilt sensor OK, check wire and repair if necessary. From tilt sensor connector X 296 Pin 1 to DWA control unit connector X252 Pin 3,

If wire OK, check following wires and repair if necessary:

From tilt sensor connector X 296 Pin 2 to DWA connector X 335 Pin 2 and from X 296 Pin 5 to DWA control unit connector X 252 Pin 5.

If all wires OK and detect still Not rectified, check ground wire of tilt sensor and repair if necessary: From connector X 296 Pin 4 to ground.

Pin assignments at tilt sensor connector X 296

Pin 1: Signal wire from tilt sensor to DWA control unit
Pin 2: Terminal 30
Pin 3: Not used
Pin 4: Ground wire (B-)
Pin 5: Control wire from DWA control unit to tilt sensor for arm/disarm commands