Convertible Top Latch: Adjustments

ADJUSTING LEFT OR RIGHT CONVERTIBLE TOP LOCK (POWER/FULLY-AUTOMATIC):




Ideal adjustment:
- Lid should close flush with windshield.





NOTE:
- Open convertible top up to microswitch (S8) "convertible top switches via dead center point".
- Removing and installing finisher on convertible top lock.
In addition, on right convertible top lock:
- Removing and installing motor for convertible top lock




- Lift out retainer (1) and disconnect ball pan (2). Pull input shaft (3) off motor.




- Adjust dimension (A) of dead center point rod (1) from center of ball pan (2) to center of screw connection (3).

Dimension (A) = 205.5 +/- 1




- Unfasten guide (1), remove completely and wipe away screw retainer fluid with a cleaning cloth.
- Adjust input shaft (2) by hand until screw (3) is accessible for tool.

Installation:
- Install guide (1) with Loctite 243 (Sourcing Reference: BMW Parts Service).

Tightening Torque: 8 Nm




- Loosen screws (1) and nuts (2).
- Adjust height using adjusting screw (3).
- Tighten down screws (1) and nuts (2).
- If applicable, adjust base plates.