Convertible Top Latch: Service and Repair

REPLACING BOTH CONVERTIBLE TOP LOCKS (POWER/FULLY-AUTOMATIC):

NOTE:
- Open convertible top as far as microswitch (S8) "convertible top switches via dead center point".
- Removing and installing finisher on convertible top lock.
In addition, on right convertible top lock:
- Removing and installing motor for convertible top lock.




- Lift out retainer (1) and disconnect ball pan (2).
- Pull input shaft (3) off motor.
In addition, on left convertible top lock:
- Pull off connector (4), unlock housing (5) and remove from bracket.




- Unfasten guide (1), remove completely and wipe away screw retaining fluid with a cleaning cloth.
- Adjust input shaft (2) by hand until screw (3) for tool is accessible.
Installation:
- Install guide (1) with Loctite 243 (Sourcing Reference: BMW Parts Service).
Tightening Torque: 8 Nm




- Unfasten screws (1) and nuts (2).
- Pull convertible top lock (3) upwards to remove.





Installation:
Adjust dead center point rod (1):
- Preset dimension (A) of dead center point rod (1) from center of ball pan (2) up to center of screw connection (3).
Dimension (A) = 205.5 +/- 1
- Adjusting left or right convertible top lock.