Removing and Installing

Removing And Installing Shift Lever




- Pull shift lever knob off by hand with a sudden jerk.
- Pulling-off force: approx. 400 N.




- Lift and pull cover off shift lever.
- Remove foam rubber cover (if fitted).




- Lift off retainer (1).
- Remove window (2).
- Remove selector rod (3).

Installation:
- Coat bearing with Kluber Polylub GLY 801




- Fit special tool 25 1110 and rotate counter-clockwise through 90°.
- Press up bearing shell.




- Pull rubber grommet out of body opening and remove upward together with shift lever.




Installation:
- Insert rubber grommet with arrow facing forwards in driving direction.




- Coat bearing shell with Polylub GLY 801.
- Insert shift lever with bearing shell.
- Mount bearing shell in such a way that tabs or arrows on bearing-shell point in direction of bearing pin.




- Press down on bearing shell at point of retaining tabs until the are heard to engage.




- Button in inner dust cover over shift arm and outer dust cover in body opening.