Section C: Defect Code 00 13 04 01 00 and 00 12 08 01 00

(Resetting EML Adaptation Values on all affected vehicles if a component(s) was replaced)

1. Reconnect battery, connect DIS and turn ignition to the on position (engine not running).

2. Select "Engine Power Control".

3. Select "3 Service Functions".

4. Select "5 Reset adaptation values".

5. Select "1 Pedal travel sensor adaptation values".
Page back <-

6. Select "2 Throttle valve adaptation values".
Page back <-

7. Select "3 Cylinder bank synchronization".
Page back <-
Page back <-

8. Select "1 Execute basic pedal-travel-sensor adaptation". Follow the instructions given in order to adapt PWG sensor.

NOTE:
It is important that the accelerator pedal be fully depressed when "kickdown end position" is requested otherwise the status values will not go beyond status 3.

If status 5 is not reached, turn the ignition off for at least 10 seconds to allow the system to reset. The status value must be at 1 after the ignition is turned to the on position, in order to allow the adaptation process to be repeated.

Continue to reset the system and repeat the adaptation process until status 5 is reached.

Once status 5 is reached with accelerator not depressed turn the ignition off for 10 seconds. The status value must be at 0 after the ignition is turned to the "on" position, otherwise the adaptation process must be repeated.

9. Once throttle response has been verified with engine running - clear all faults set in the EML control module.