Adjusting Sun Roof Lid
Adjusting Sun RoofCaution! Do not move floating roof liner with force. Follow procedure precisely because otherwise mechanism (guide) on slide/tilt sunroof cassette can be damaged. It then has to be replaced.
Ideal adjustment:
Gaps (A) between sunroof and front and back of roof of equal size.
Height:
Front = flush to 1 mm deeper
Rear = flush to 1 mm higher
Initializing slide/tilt sunroof.
Closing slide/tilt sunroof lid (zero setting).
Press button to open roof briefly (1) then stop again (2) (inching function).
The slide/tilt sunroof lid must now lower at back by dimension (A).
(A) = 2...4mm
Caution! Swift movement of the slide/tilt sunroof can damage mechanism (guide) of the slide/tilt sunroof cassette.
Do not move floating roof liner with force.
Slowly slide floating roof liner right back (with clean hands, or wearing protective gloves).
Closing slide/tilt sunroof lid (zero setting).
Caution! It is now no longer possible to move slide/tilt sunroof lid backwards (damage to mechanism).
Rear adjustment:
Unfasten nut (2) and replace.
Slide in adjusting wedges (1) on left and right until ideal setting is reached.
Press slide/tilt sunroof lid forwards, then tighten the outer nut (2) first of all.
Tightening Torque: 4.5 Nm (3.3 ft. lbs.)
Front adjustment:
Loosen left/right screws (1).
Push slide/tilt sunroof lid upwards or downwards until ideal setting is reached.
Tighten screws (1).
Installation:
Tightening Torque = 4.5 Nm. (3.3 ft. lbs.)
Replace removed screws (micro-encapsulation) or install old screws with Loctite 270.
Press button to open roof briefly (1) then stop again (2) (inching function).
The slide/tilt sunroof lid must now lower at back by dimension (A).
(A) = 2...4mm
Caution! Swift movement of the slide/tilt sunroof can damage mechanism (guide) of the slide/tilt sunroof cassette.
Pull floating roof liner forwards (with clean hands or wearing protective gloves).
Installation:
Check function.