Check Control Display Procedures

CC DISPLAY PROCEDURES

Special Displays - These messages will overwrite all other displays. If more than one special display request is received by the CCM, the one with the highest priority will be delivered.

P1 Group - P1 displays remain posted as long as the fault is present. If several P1 warnings have been received by the CCM, they are displayed one after another in 3 second intervals.

P2 and P3 Groups - The messages in both groups are displayed when KL15 is switched on for a maximum of twenty three (23) seconds and P3 messages are not displayed after the trip is started. P2 and P3 warning that have been registered by the CCM can be recalled during the trip by pressing the CC button.

Reminder Symbol "> <" - The '+" symbol is no longer used. If more than one P1 check control message is present, the reminder symbol "> < "is illuminated permanently. If a P2 or P3 message is extinguished, the reminder symbol informs the driver that a CC message has been posted. The symbol will flash when a new P1 warning is recognized.







CC Button - Check control messages can be recalled, for up to 3 minutes, after the ignition is switched off using the CC button.

The highest priority message is displayed first with following messages in a priority descending order. After the lowest message has been displayed, pressing the CC button will clear the matrix.

"Check Control OK" is posted when the CC button is pressed and there are no warning message present.







Steering column switch (LSS) - Pressing the steering column switch will clear the matrix display if low priority messages are being posted. This will allow the display to be utilized for other information.

Gong - The warning gong is activated by the IKE when the CCM sends the proper data over the I Bus. The gong is activated only when higher priority warnings are posted.