Driver's Side

WARNING: Review Service Precautions. Improper handling could cause activation of the airbag(s) and lead to injuries! Service Precautions

CAUTION:
- Disconnect battery and cover negative pole or terminal.
- Unscrew screw.
- Pull lower section of steering-column casing off upper section.





Installation Note:
- Check for correct position of lock.





- Pull (orange) plug-in connection out of holder on steering column and disconnect.
- Remove screws (Torx T 30 socket).





Installation Note:
- First tighten screws on right-hand side in forward direction.
- Do not pinch wires.
Tightening torque;
Airbag unit to steering wheel = 8 Nm





- Pull off connector and remove airbag unit.

CAUTION: Airbag unit must always be laid to one side (in luggage compartment) with impact pad facing upwards.

- Turn steering wheel to straight-ahead position (markings on steering gear and steering spindle aligned).





- Unscrew bolt.
- Mark position of steering wheel relative to steering spindle.
- Pull off steering wheel.





NOTE: Loosening screw activates spring clip (1) which holds contact ring in center position.





Installation Note:
- Lockpin (1) must engage in opening (2) of contact ring.
Tightening torque;
Steering wheel to steering spindle:
Nut = 80 Nm
Screw = 63 Nm





Adjust contact ring if necessary:
- Press down spring (1). Turn contact clockwise or counterclockwise as far as stop. Turn back about 3 turns until arrows for center position are aligned.
- Release spring (1).





Installation Note:
- Coat slip ring with grease.