Removing and Installing Instrument Carrier

- Unscrew screws and lift out instrument cluster upwards slightly and pull forward as far as steering column.


CAUTION: Place cleaning rags on steering column to avoid scratches in glass of instrument carrier.





- Push forward levers on connectors and take out connectors.

Installation:
- When inserting a connector, lever must be in forward position.




- Unscrew button for light switch and pull out instrument carrier sideways.

Installation:
- Convert and reset encoding connector when replacing instrument carrier. Refer to Test Functions, 15 and 09. Testing and Inspection




- Pull cover (1) off blue connector on instrument cluster.




- Press contact carrier (3) with wiring through aperture. Check whether chamber 21 is fitted with a brown ground wire. If not, insert wire supplied into chamber 21.




- Cut open wiring harness slightly behind the white connector and fit the supplied crimp connector around the brown-orange wire from chamber 24.
- Insert the additional wire from blue connector into an additional chamber on the crimp connector. Ensure that the end of cable does not protrude from the crimp connector.




- Fold over crimp connector and compress. At this point, the comb connector cuts into the core of the wire, thereby establishing contact.