Engine Removed

(Engine removed)





Fit engine to special tool 00 1 450.

Caution: Only raise engine on locating lugs provided for this purpose. Layout of front engine mount.





Layout of rear engine mount.





Raise engine with special tool 11 0 000.
Remove oil dipstick guide.
Remove carrier bracket from cylinder bank 1 to 4.





Fit special tool 11 0 081 to cylinder bank 1 to 4.





Remove carrier bracket from cylinder bank 5 to 8.





Installation:
Replace sealing rings, ensure that seals are correctly located and, if necessary, secure with grease.





Fit special too 111 0 082.





Install engine in special tool 00 1 450, locate locking detent (1).
Close locking detent (2) on right and left and screw down.
Subsequent procedure is described in the work step, Removing and installing left cylinder head.