System With ABS

Caution: Note "General Information", refer to General Data found in Brakes and Traction Control, Description and Operation.





Use a suitable Bleeder device. Attach to expansion tank.

Note: Check relevant operating instructions for each device.

Charging pressure must not exceed 2 bar.





Connect bleeder hose with bottle to rear-right brake caliper. Open bleed valve and fully depress brake pedal at least 12 times.

Note: Brake fluid must emerge without bubbles.

Hold down brake pedal in fully depressed position.
Close bleeder valve.
Release brake pedal.
Follow same procedure on wheel brakes rear left, front right and front left.

Caution:
With fixed caliper, bleed both sides of brake caliper, removing wheel if necessary.





Switch off bleeder unit and disconnect from expansion tank.
Check brake fluid level.
Close expansion tank.

Note: Take care of rubber gasket (1) in lid.