Replacement Transmission

Installing replacement transmission (S5D 260Z/310Z/320Z)

Note: Removing and installing transmission (S5D 260Z/310Z/310Z).





Note: Before installing the transmission, fit breather (1) (refer to sticker).

Remove breather (1) and protective sleeve (2) from selector shaft.
Lift off sealing cap (3) and install breather (1).
Installing release unit and release lever in the new transmission, refer to Clutch M/T.





Transfer shift-rod joint.
Slide back retaining sleeve or retaining ring (1).
Drive out cylindrical pin (2).
Transfer exhaust carrier and backup light switch.

Note: Transmissions are supplied filled with oil.

For this reason it is only necessary to check oil level after installation of transmission.