"1 Customer Service Measures"

Programming Procedures For "1 Customer Service Measures"

Prior to any type of programming, make sure the DME fault memory is cleared and vehicle battery is fully charged!

This procedure is for special program updates only. The software contains the update information that is added to the existing control module EPROM.

1. Connect the MoDiC to the 20 pin diagnostic connector. Turn the ignition switch ON. The "BMW MoDiC" opening screen will momentarily display.

2. Select "2 Programming" and press the enter button.

3. The Programming software version is displayed. Make sure it is the latest version. Press the down arrow.

4. Enter the date and press the Y button.

5. Select "3 DME Programming" and press the enter button.

6. Select "1 Determine Customer Service Measures" and press the enter button.

7. "Engine off, Ignition On". Press the right arrow button.

8. Press the Y button to start automatic determination as covered in the beginning of this section.

9. Press the right arrow button.
10. The VIN is displayed. If the displayed VIN matches the vehicle press the Y button. Press the N button if it does not match and enter the VIN manually then press the Y button.
11. If there are no service measures available for the control module the message "No customer service measures available for this control module" will be displayed.
If the software contains a service measure, select the number and press the enter button.
12. The message ".... service measure was selected" will display. Press the enter button to start the update.
13. When the update is complete the MoDiC will display "Service Measure update complete".