Exhaust System: Service and Repair

Special tools required:
- 31 2 220

Warning!
Scalding hazard!
- Only perform this work after engine has cooled down.




- Release hexagon nuts (1).
Installation note:
- Replace self-locking nuts.
- Coat threads with -CRC- copper paste.



- Check seals (1) replace if necessary.



- Release screw (1) and remove exhaust bracket.
Installation note:
- After complete installation of exhaust system align exhaust carrier so that it is free from tension. To do so slacken screws (2).



- Support exhaust system with jack and special tool 31 2 220 and secure against falling out.



- Release hexagon screws (1 and 2) and remove reinforcement plate (3). Front reinforcement plate is connected to exhaust system via rubber mounts.



- Release hexagon nuts (1) of front rubber mount on rear muffler.



- Release hexagon nuts (1) of rear rubber mount on rear muffler. Remove complete exhaust system.