Replacing Lock, Seat Back-Rest (Through-Loader) (Touring)

Removing And Installing/Replacing Lock For Left Rear Seat Back-rest (Through-Loader) (Touring)







Loosen screw (3)
Press lock finisher (2) upwards slightly until clip (1) is free, then carefully pull lock finisher (2) outwards to remove.







Installation Note: Clip (1) of finisher (2) may not be damaged.







Partially lift out cover (1) on rear seat back-rest.







Remove retaining plate (1) and disconnect actuating rod (2) to unlock back-rest.

Installation:
Fit bush (3) and new retaining plate (1).
Perform function check with rear seat back-rest folded forwards.







Unfasten screws and fold lock for back-rest lock toward front.







Summary of left lock for back-rest lock:
1. Actuating rod to lock back-rest
2. Lower section of left lock for back-rest lock
3. Bowden cable of safety belt
4. Left lock of back-rest lock
5. Bush for mounting of actuating rod back-rest locking fixture







Unhook Bowden cable of safety belt on back-rest lock:
Press lever (1) forwards in direction of arrow.
Remove sleeve of Bowden cable (2) from bracket (3) in lock of back-rest lock.
Unhook Bowden cable from lever (1).







Summary of left lock for back-rest lock:
1. Left actuating lever for back-rest lock
2. Hole for Bowden cable of safety belt
3. Retaining lug for Bowden cable on actuating lever for backrest lock
4. Bracket for Bowden cable of safety belt
5. Bowden cable sleeve
6. Bowden cable of safety belt