Replacing Selector Rod Joint

Unflange propeller shaft from transmission, refer to Drive Propeller Shafts, Bearing and Joints.





Detach locking clamp.





Withdraw shift rod (1) from shift rod joint (2) and remove disks (3).

Installation:
Grease shift rod pin (4).
Use suitable grease.
Large contact surface of disks (3) must rest against shift rod joint (2).





Lever spring washer (1) out of groove and push a little towards rear.
Press straight pin (2) upwards or downwards out of shift rod joint and remove shift rod joint.





Installation:
Grease ball of transmission selector shaft.
Use suitable grease.
Replace spring washer (1).

Installation:
Check rubber ring (1) in shift rod joint (2) and replace if necessary.