Components, Locations and Removal Information

COMPONENTS

ON-BOARD MONITOR ASSEMBLY
The on-board monitor assembly is mounted in the center console. It consists of the following components:




REMOVAL OF ON-BOARD MONITOR ASSEMBLY FROM CENTER CONSOLE
The on-board monitor is removed from the center console as an assembly as follows.




1. Remove the wood trim from the dash on both sides of the on-board monitor.
2. Unscrew the metal plates (E38) or unhook the latches (E39) from each side of the on-board monitor and loosen the recessed screw from the lower edge of the wood trim.




3. Remove the on-board monitor wood trim
4. With the on-board monitor wood trim removed, unscrew the four large torx[TM] screws as shown.
5. Pull the on-board monitor assembly out of the center console.

The following components are mounted in the trunk on the left side behind the trim cover




NAVIGATION COMPUTER REMOVAL




To remove the nav. computer from the mounting bracket insert four small Phillips head screwdrivers into the four holes on the face plate. Push the screwdrivers in past a slight detent. Pull the nav. computer out of the mounting bracket.

The following components are located on the rear parcel shelf under the trim panel.




Carry over components that are part of the On-Board Monitor/Navigation system include:
- Instrument Cluster Control Module (IKE) for On Board Computer calculations
- Multi-Function Steering Wheel (MFL) for radio and telephone control functions.
- Telephone handset for operation of the phone.
- ASC control module for the two front wheel speed sensor inputs.