Airbag Control Unit
WARNING: Review Service Precautions. Improper handling could cause activation of the airbag(s) and lead to injuries! Service PrecautionsImportant!
- Disconnect negative battery lead.
- Press fresh-air grill and finisher strip or heater control apart somewhat, unclip finisher strip or heater control at top and remove.
- Push fresh-air grill approx. 30 to 40 mm downward and remove.
Installation Note:
- Guide in fresh-air grill centered and press completely upward. Then install finisher strip or heater control.
- Pull connector off finisher strip or heater control and lay aside.
- Release nuts and lift out control unit.
Installation Note:
- Before installing control unit, make sure the ground lead is fitted on stud bolt (1).
- Unlock connector and remove.
- Lift out central unit.
After replacing the control unit, it must be re-encoded,
refer to Diagnosis Information System (DIS).