Radius Arm: Service and Repair

Removing And Installing Or Replacing Both Traction Struts

Caution! Always install or replace traction strut bearings in pairs.

Unscrew and remove splash guard.
Unfasten nut.
Unfasten stabilizer mount on front axle support.





Remove screw (1) and turn steering onto lock if necessary.

Installation:
Replace self-locking nut.
Tightening Torque, refer to Suspension Specifications.





Mark the installation position of the spring strut tube (1) in the swivel bearing (2) with paint - never mark with scribing tool. Marking is not required if the factory mark is still identifiable.
R = installation position of right spring strut tube
L = installation position of left spring strut tube





Version with factory marking above the swivel bearing.
Unfasten nut.





If necessary, expand the swivel bearing with special tool 31 2 200 and press downwards.

Installation:
Press swivel bearing up to stop and note the mark indicating the installation position.
Replace self-locking nut. Tightening Torque, refer to Suspension Specifications.

Unfasten nut.





Press off ball joint with special tool 31 2 240.
Remove traction strut.

Installation:
Tapered spigot and bore both free of grease.
Use washer (1). Replace self-locking nuts.
Tightening Torque, if necessary brace on hex cap nut, refer to Suspension Specifications.