Replacing Shift Arm For Shift-Lever Mount

Remove propeller shaft from transmissions, refer to Drive Propeller Shaft, Bearings and Joints.
Remove shift lever.





Using a mandrel, release thrust bearing (1) from bracket.





Installation:
Clip mount (1) in holder with arrow (2) facing up.





Support transmission from underneath.
Unscrew cross member from body.
Lower transmission.





Lift spring (1) off tab (2) on case using a screwdriver and swing upwards.
Pull out shaft.

Installation:
Insert shaft pin with Kluber Polylub GLY 801, or equivalent





Remove shift arm.
Pull off mount (1).

Installation:
Position mount with opening (3) facing rear of vehicle.
Coat mount with Kluber Polylub GLY 801, or equivalent





When replacing bearing sleeve: Press out bearing sleeve.
Coat new bearing bush with Circolight and press into place.