Manual

FRONT SEATS

Warning!
- Note safety regulations on handling airbag modules and pyrotechnically seatbelt tensioners.
- Improper handling can lead to triggering of the pyrotechnically seat belt tensioner or side airbag, resulting in injuries.
- Switch off ignition.

- Adjust front seat as far forward and upward as possible.




- Unfasten seatbelt screw.

Tightening torque
- Safety belt on, except for B-pillar 48 Nm
- Safety belt on B-pillar 31 Nm
- Safety belt on seat 48 Nm




- Pull retainer (1) backwards to unlock and pull inwards to remove. Lift Bowden cable (2) forwards to remove for seat belt adjustment.





Important!
- Failure to comply with this disassembly sequence causes the web (4) to break, thus destroying the finisher.

Adjust front seat to maximum forward position.
1. Raise finisher slightly on detent head,
2. Unfasten and raise inner clip lugs,
3. Pull finisher backwards to remove.





- Disconnect connector (1) and remove (2).





- Unfasten screws.
- Move front seat as far back as possible.

Installation Note:
- Replace screws (microencapsulation) or install old screws with Loctite 270.





- Unfasten screws and lift out front seat.

Installation Note:
- Replace screws (microencapsulation) or install old screws with Loctite 270.





Installation Note:
- Floor carpet must not enter area between seat rails and floor panel beside screw points (grating noises).

Installation sequence:
- Rear seat rails flush on underside
- Lift front seat into vehicle
- Unlock longitudinal adjustment on lever (seat rails clip in at back)
- Install screws loosely in back
- Slide front seat completely back (can also be set at an angle)
- Align front seat
- Install front screws loosely

Tightening sequence:
- Tightening torque, Seat to floor plate 42 Nm
- Tighten down front inside and outside screws
- Adjust front seat to front detent setting
- Tighten down inner and outer screws at back