Replacing Seat Cover on Front Seat (Comfort)

Replacing Seat Cover On Left Or Right Front Seat (Comfort)

Removal of complete seat cushion:
Remove both seat rails.
Remove inside cover.
Remove cover.
Remove backrest.








Disconnect cover and remove with foam rubber section (support).


NOTE: The operation "Removing seat cover with support" ends here.


Replacement of support:







Cut through all clips and remove seat cover from support (foam rubber section).

Installation Note: Lock new retainer by bending it with special tool 52 0 050.







Only on leather version:

Installation:
If necessary, lift foam rubber strips (1) forwards, cut through clips (2) and expose trim thread (3).







Only on leather version:

Installation:
If necessary, the ducts which were not used must be sealed with foam rubber strips (1).







Only on leather version:

Installation: At side and front, secure two ends of cover (trim threads) with a clip.
1 Support
2 Clip
3 Trim a thread in support
4 Cover and trim thread
5 Cover and trim thread







Only passenger seat (replacement of support):

Installation:
Fit new sensor mat.
Mark out points (2) on sensor mat (1) for passenger seat allocation identification on liner and attach to foam rubber.
Guide connector through the bore (3).
Folds as illustrated in diagram are not permitted!


NOTE: The operation "Replacing support" ends here.







Replacement of sensor mat (only passenger seat):
Remove sensor mat (1) for passenger seat allocation identification, ensuring that no large areas of foam at damaged marked points (2) (malfunction of passenger seat allocation identification). Guide connector through the bore (3).
Folds as illustrated in diagram are not permitted!


NOTE: The operation "Replacing sensor mat" ends here.







Replacement of seat cover:
Remove trim threads from cover. Cut new cover and insert trim threads.
Only with leather version: trim threads (1) are additional items.